Rice Lake Digital/Diagnostic - iQube - Manual (Page 46)

920i Serial Commands 43
Command Description Values
SJ.SYS.NAME.s#n System name System1, system_name (24 characters, maximum)
SJ.SYS.PLATS.s#n System platforms 0,0,0,0 (specify platform numbers, 1–4, assigned to sytem)
or NONE (to clear platform list)
For system (SJ.SYS.) commands ending with “s#n”, s is the system number, n is the 920i serial port number.
Table 8-4. 920i iQUBE System Serial Commands
Command Description Values
SJ.DIAG.ZEROREF#n Zero reference diagnostic enable ON, OFF
SJ.DIAG.ZR.THRH#n Zero reference threshold 0.0–9.999999
SJ.DIAG.ZR.%THRH#n Zero reference percent threshold 0–100
SJ.DIAG.ZR.DELAY#n Zero reference delay 0–65535
SJ.DIAG.CELLBAL#n Cell balance diagnostic enable ON, OFF
SJ.DIAG.CB.THRH#n Cell balance threshold 0.0–9.999999
SJ.DIAG.CB.%TOLR#n Cell balance percent tolerance 0–100
SJ.DIAG.CB.LOAD#n Cell balance load 0.0–9999999.0
SJ.DIAG.LDRIFT#n Load cell drift diagnostic enable ON, OFF
SJ.DIAG.LD.LIMIT#n Load cell drift limit 0.0–9.999999
SJ.DIAG.LD.%LIMIT#n Load cell drift percent limit 0–100
SJ.DIAG.LD.TIME#n Load cell drift time 0–65535
SJ.DIAG.LD.LOAD#n Load cell drift load 0.0–9999999.0
SJ.DIAG.PKTOPK#n Peak-to-peak diagnostic enable ON, OFF
SJ.DIAG.PK.LIMIT#n Peak-to-peak limit 0.0–9.999999
SJ.DIAG.CELLEMU#n Cell emulation enable ON, OFF
SJ.DIAG.CE.TYPE#n Cell emulation type AUTO1, AUTO2, MANUAL1, MANUAL2
SJ.DIAG.MOTBAND#n Motion band 0.0–9999999.0
For commands ending with “#n”, n is the number of the 920i serial port to which the iQUBE is attached.
Table 8-5. 920i iQUBE Diagnostic Serial Commands