Rice Lake Counterpart Configurable Counting Indicator - Installation and Operation Manual V2.3 - Rev C - Manual (Page 87)

Print Formatting 81
Suppress units. Toggle weight data format (formatted/unformatted)** GFMT, NFMT, TOTALFMT,
PALFMT, CFMT, ACCFMT
HDRFMT1, HDRFMT2
or Supress units and lead spaces
Outputs K (kg) or L (lb) or O (oz).
Setpoint captured weight value SPFMT
Setpoint weight number
Setpoint target weightvalue
Setpoint preact weight value
Setpoint weight mode
Setpoint captured count value
Setpoint target count value
Setpoing preact count value
Gross, net, and tare weights are 8 digits in length, including sign and decimal point, followed by a space and a one- to five-digit
units identifier. Total field length with units identifier is 10-14 characters. Depending on what units are configured, the units
identifier will be lb, oz, g, or kg.
Gross, net, tare, and accumulator weights can be printed in any configured weight units by adding the following modifiers to the
gross, net, tare, and accumulator weight commands: /P (primary units), /D (displayed units), /S (secondary units), /T (tertiary
units). If not specified, the current displayed units (/D) is assumed. Example: To format a ticket to show net weight in secondary
units, use the following command: .
UNIT ID and consecutive number (CN) fields are 1–6 characters in length, as required.
* If nn is not specified, 1 is assumed. Value must be in the range 1–99.
** After receiving an WA command, the indicator sends unformatted data until the next WA command is received. Unformatted
data omits decimal points, leading and trailing characters.
Command Description Supported Ticket Formats
Table 7-1. Print Format Commands