Rice Lake Counterpart Configurable Counting Indicator - Installation and Operation Manual V2.3 - Rev C - Manual (Page 59)

Configuration 53
3.10 Setpoints – Weigh Mode Parameter Menu
Set up of setpoints is allowed while in the weigh mode.
While setting up setpoints, the Access parameter needs to be set to either On or Off.
• Setting it to On allows a setpoint to be viewed and edited if setpoint type is Gross, Net, Piececnt, %Rel, Delay,
or Counter.
• Setting it to Off allows a setpoint to be viewed but not edited if the setpoint type is Gross, Net, Piececnt, %Rel,
Delay, or Counter.
• Hide will not show the setpoint.
Figure 3-25. Setpoint Menu in Weigh Mode
Parameters Choices Description
SETPT1-6 OFF
GROSS
NET
PIECECNT
%REL
DELAY
WAITSS
COUNTER
INMOTION Specifies the setpoint kind.
GROSS, NET, PIECECNT, and %REL setpoint kinds can be used as either batch or continuous
setpoints. DELAY, WAITSS, and COUNTER setpoint kinds can only be used in batch
sequences.
The INMOTION setpoint kind can only be used as a continuous setpoint.
Table 3-20. Setpoint Menu Parameters in Weigh Mode
ID DISPLAY TEST SETUP AUDIT CALIBR SETPTS
BANDVAL
number
If TRIP=
INBAND or
OUTBAND
If TRIP=
HIGHER or
LOWER
HYSTER
number
If PREACT=
ON or
LEARN
PREVAL
number
If KIND=
% RELSP
RELNUM
1-6
PRESTAB PCOUNT PREADJ
number
If PREACT
=
LEARN
VALUE
number
GROSS NET PIECECNT %REL
In Weigh Mode
DELAY COUNTER
VALUE
number
VALUE
number
SAME AS SETPT 1
SETPT 1 SETPT 2 - 6