Rice Lake Counterpart Configurable Counting Indicator - Installation and Operation Manual V2.3 - Rev C - Manual (Page 12)

6 Counterpart Counting Scale Indicator
Set Date and Time
1. If the softkey is enabled, push the softkey. The current value is displayed.
2. To change, use the Up/Down arrows to highlight the value to change.
3. Press the TARE key to save and exit.
Set Serial Scale (Scale 3)
1. Select Port 1 — Indust Scale.
2. Match the baud rates. Upon doing this it automatically becomes Scale 3.
Setting up a Softkey
To set up a softkey, use the following steps:
1. Press the MENU SETUP key.
2. Navigate through the menu setup to Setup using the key.
3. Press
to navigate to CONFIG .
4. Press to navigate to SCALES.
5. Press to navigate to FEATURE.
6. Press to navigate to COUNT.
7. Using scroll through until you get to SOFTKEYS .
8. Scroll down. Then using scroll through menu selections SK1 through SK12.
9. Press to assign a softkey to that position.
10. Select a choice that you wish to be displayed.
11. Press once the function is selected.
12. Press
Save/Exit softkey.
MENU
SETUP