Rice Lake Counterpart Configurable Counting Indicator - Installation and Operation Manual V2.3 - Rev C - Manual (Page 10)

4 Counterpart Counting Scale Indicator
Figure 1-1. Numeric Keypad
Additional Keypad Symbols
Additional symbols can be accessed by pressing the following keys.
1.5 Tare Recall
When a stored tare is displayed, Net annunciators will be turned on. To display a stored tare,
1. Set up a softkey (see Softkey Setup in Section 1.7 on page 5).
2. Press the DISPLAY TARE softkey .

The tare value will be displayed. If there is no tare in the system, pressing the TARE key will have no effect.
The Gross/Net annunciators are not lit and a value is displayed in weight display area.
1.6 Annunciator Symbols
Key Symbol
1 <
>
-
+
*
$
/
%
"
0 *
. (period) space
Table 1-3. Additional Keypad Symbols
Annunciator Description
Zero (Center of Zero)
While in gross weight display mode, this LED indicates that the current displayed weight reading is within +/-0.25 display
divisions of the acquired zero, or is within the center of zero band.
When in the net weight display mode, it indicates that the current net weight reading is within +/-0.25 display divisions of the
center of net zero. A display division is the resolution of the displayed weight value, or the smallest incremental increase or
decrease that can be displayed or printed.
G/B Gross weight mode (or Brutto in OIML mode)
N Net weight display mode
Indicates the level of the battery.
Scale is at standstill or within the specified motion band. Some operations, including tare functions and printing, can only be
done when the standstill symbol is shown.
Table 1-4. Annunciator Symbols
0