Rice Lake CLS-920i Cargo Lift Scale Installation Manual - Manual (Page 60)

56 CLS-920i Installation Manual
Allow New
Employee IDs Yes Yes/No The 920i has an employee database that
holds up to 1000 employees ID numbers.
When an employee logs in by entering or
scanning his employee ID, the database is
searched for a matching ID. If not found, this
error message appears, Employee ID not in
DB when new employee IDs are not allowed.
If the employee ID is being scanned from a
badge and there is no chance of data entry
error, then this setting can be set to YES. In
that case, the first time a new employee ID is
scanned, it will be entered into the database
and the message New Employee: nnnn
stored in Database is displayed (where nnnn
is the new employee ID.
Report
Header
Information Address Line 1 30
Character
String The address lines are up to four lines of 30
characters each. This text will be printed on
the top of each report.
Address Line 2
Address Line 3
Address Line 4
Towmotor ID The towmotor and Scale IDs are additional
pieces of information that will be printed on
each report.
Scale ID
Calibration
Check Value Calibration
Weight ID # 12
Character
String The calibration check values are present in
this list for viewing purposes only. These
values are set when the calibration check
procedure is performed after pressing the
Calibration Check softkey.
Calibration
Weight 0 32000
Real
Measured
Weight 0 32000
Real
Last Calibration
Time & Date 20
Character
Date
Serial Ports Scanner Port 1 1 12 Port The serial ports can be changed if necessary.
The 920i has 4 serial ports on the CPU board.
Ports 7 and 8 may also be available if the
wireless LAN option card is installed.
Note
iQube must be configured into
Port 4 and the default values
cannot be changed.
Report Printer
Port 3 1
iQube Port 4 1
PC Interface
Port 2 1
Debug Port 0 0
Parent List Parameter Name Default Value Min Max Type Description
Table 5-1. Supervisor List Parameters