Rice Lake CLS-920i Cargo Lift Scale Installation Manual - Manual (Page 45)

CLS-920i Installation Manual 41
FEATURE Menu, CONTACT Submenu
The CONTACT submenu allows entry of contact information for a contact company or scale dealer. Contact
information can be displayed by pressing the
Contacts softkey on the Version menu in setup mode or the
Diagnostics softkey when in weigh mode. Contact information may be used in print formats.
BEESFTT@MJOF@ BEESFTT@MJOF@ BEESFTT@MJOF@ DPOUBDU@OBNF@
4$"-&4 4&3*"- '&"563& 1'03.5 4&5154 %*(*0 "-(065 7&34
$0/5"$5
$.1/: "%%3 "%%3 "%%3 /".& /".& /".&
1)0/& 1)0/& 1)0/& &."*-
QIPOF@OVNCFS QIPOF@OVNCFS QIPOF@OVNCFS FNBJM@BEESFTT
DPOUBDU@OBNF@ DPOUBDU@OBNF@ DPNQBOZ@OBNF
/&95$"-
EBUF
Figure 4-11. CONTACT Submenu
Table 4-7. CONTACT Submenu Parameters
FEATURE Menu, CONTACT Submenu
Parameter Choices Description
Level 3, CONTACT submenu
CMPNY company_name Enter the name of the contact company or dealer.
ADDR1–ADDR3 address Enter up to three lines of address information for the contact company.
NAME1–NAME3 contact_name Enter names of up to three contact persons.
PHONE1–PHONE3 phone_number Enter phone numbers for each of the contact persons specified for the NAMEx
parameter.
EMAIL email_address Enter the e-mail address of the contact company or dealer.
If the iQUBE alert support is used to send automated alert e-mail messages,
enter the e-mail address to which the alert messages will be sent.
NEXTCAL date Enter the next scheduled calibration date using the month/day/year format on the
DATEFMT parameter. Separator characters are not required.