Rice Lake 920i Installation Manual V2.0 - Manual (Page 89)

Serial Commands 85
9.1.5 Normal Mode Commands
The normal mode print commands (see Table 9-11) transmit data to the serial port on demand in either setup or
normal mode.
ALG.MODE#s Mode GROSS, NET
ALG.OFFSET#s Zero offset 0%, 20%
ALG.ERRACT#s Error action FULLSC, HOLD, ZEROSC
ALG.MIN#s Minimum value tracked 0–9999999
ALG.MAX#s Maximum value tracked 0–9999999
ALG.ZERO#s Zero calibration 0–65535
ALG.SPAN#s Span calibration 0–65535
For commands ending with “#s”, s is the slot number.
Command Description Values
Table 9-10. ALGOUT Serial Commands (Valid Only If Analog Output Card Is Installed)
Command Description Values
CONSNUM Set consecutive number 0–9 999 999
UID Set unit ID nnnnnnn
SD Set date MMDDYY, DDMMYY, YYMMDD, or YYDDMM. Enter six-digit
date using the year-month-day order specified for the
DATEFMT parameter, using only the last two digits of the year.
ST Set time hhmm (enter using 24-hour format)
SX#n Start serial port streaming OK or ??
The port streaming parameter (EDP.STREAM#p) for the
streaming port must be set to LFT or INDUST before using
these commands.
An EX command sent while in setup mode does not take
effect until the indicator is returned to normal mode.
EX#n Stop serial port streaming
RS Reset system Soft reset. Used to reset the indicator without resetting the
configuration to the factory defaults.
XA#n Transmit accumulator value in displayed units nnnnnn UU
XAP#n Transmit accumulator value in primary units
XAS#n Transmit accumulator value in secondary units
XAT#n Transmit accumulator value in tertiary units
XG#n Transmit gross weight in displayed units nnnnnn UU
XGP#n Transmit gross weight in primary units
XGS#n Transmit gross weight in secondary units
XGT#n Transmit gross weight in tertiary units
XN#n Transmit net weight in displayed units nnnnnn UU
XNP#n Transmit net weight in primary units
XNS#n Transmit net weight in secondary units
XNT#n Transmit net weight in tertiary units
XT#n Transmit tare weight in displayed units nnnnnn UU
XTP#n Transmit tare weight in primary units
XTS#n Transmit tare weight in secondary units
XTT#n Transmit tare weight in tertiary units
Table 9-11. Normal Mode Serial Commands