Rice Lake 920i Installation Manual V2.0 - Manual (Page 25)

Configuration 21
3.1.3 Front Panel Configuration
Use the CONFIG submenu under the SCALES menu
to conÞgure A/D scales. For example, in an indicator
with a single-channel A/D card installed in Slot 1, the
Scale ConÞguration display will show the A/D listed
(
Slot 1 Channel 1 ) under the AVAILABLE A/D’s column.
Use the left navigation key to select the A/D, then
press the center softkey, Add . The A/D is then moved
to the Associated A/DÕs column. If no other A/DÕs are
listed in the
AVAILABLE A/D’s column, the center
softkey changes to Done , as shown in Figure 3-2.
Press Done to exit the Scale ConÞguration display.
See Section 10.4 on page 97 for information about
conÞguring serial scales.
Figure 3-2. Scale ConÞguration Display
The 920i indicator can be conÞgured using a series of menus accessed through the indicator front panel when the
indicator is in setup mode. Table 3-1 summarizes the functions of each of the main menus.
3.2 Menu Structures and Parameter Descriptions
The following sections provide graphic representations of the 920i menu structures and tables describing the
menu parameters. Default values are shown in bold type; numeric ranges and string values are shown in italic
type. Parameters shown surrounded by a dotted-line box only appear under the special circumstances explained
under each box.
Figure 3-3. ConÞguration Menu Flow
Menu Menu Function
SCALES Configuration Configure and calibrate scales.
SERIAL Serial Configure communications ports.
FEATURE Feature Set date and time formats, truck mode, passwords, keyboard locks, regulatory mode, and
initial consecutive number value, define softkeys and setpoint prompts.
PFORMT Print Format Set print format used for header, gross, net, truck in/out, setpoint, and auxiliary ticket formats.
See Section 6.0 on page 53 for more information.
SETPTS Setpoints Configure setpoints and batching mode.
DIG I/O Digital I/O Assign digital input/output functions.
ALGOUT Analog Output Configure analog output module. Used only if analog output option is installed.
VERSION Version Display installed software version number. The Reset Config softkey on the Version menu can
be used to restore all configuration parameters to their default values.
Table 3-1. 920i Menu Summary
SCALES SERIAL FEATURE PFORMT SETPTS DIG I/O ALGOUT VERS
Shown only if
Analog Ouptut
card is installed