Rice Lake 420 Plus HMI Digital Weight Indicator Installation Manual - Manual (Page 27)

420 Plus Installation Manual - Configuration 23
3.2.5 Program Menu
XXXXXXX XXXXXXX
PWRUPM
GO
OIML
REGULA
000000
number
CONSNU
DELAY
SETPNT PROGRM PFORMT SERIAL CALIBR CONFIG FORMAT
000000
number
CONSTU
NTEP
CANADA
1
UID
VERS DIGIN ALGOUT
DATFMT
MMDDYY
DATE
DDMMYY
YYMMDD
YYDDMM
DATSEP
SLASH
DASH
SEMI
TIMFMT
12HOUR
TIME
24HOUR
TIMSEP
COLON
COMA
NONE
COUNT
ACCESS
SPLISIZ
ACCUM
ON/OFF
ON
ON
RTZGRD
0
Figure 3-9. Program Menu
S BITS 1 STOP
2 STOP Stop bits. Sets the number of stop bits to 1 or 2.
TERMIN CR/LF
CR Termination character. Selects termination character for data sent from the EDP or printer port.
EOLDLY 000000
number End-of-line delay. Sets the delay period, in 0.1-second intervals, from when a formatted line is
terminated to the beginning of the next formatted serial output. Value specified must be in the
range 0-255, in tenths of a second (10 = 1 second).
Note
An EOL may be required for continuous transmission at slower baud rates to
ensure the receiving buffer is empty before another string is transmitted
ECHO OFF
ON This command enables or disables echoing of the serial commands sent to the indicator.
SERIAL Menu
Parameter Choices Description
Table 3-5. Serial Menu Parameters (Continued)
PROGRM Menu
Parameter Choices Description
Level 2 submenus
PWRUPM GO
DELAY Power up mode. In GO mode, the indicator goes into operation immediately after a brief power
up display test.
In DELAY mode, the indicator performs a power up display test, then enters a 30-second
warm up period. If no motion is detected during the warm-up period, the indicator becomes
operational when the warm up period ends; if motion is detected, the delay timer is reset and
the warm up period repeated.
COUNT ACCESS
SPLSIZ Specifies whether operator has access to piece count mode and the default sample size used
for parts counting. See level three submenu for parameter descriptions.
Table 3-6. Program Menu Parameters