Rice Lake 420 Plus HMI Digital Weight Indicator Installation Manual - Manual (Page 26)

22 420 Plus Installation Manual
3.2.4 Serial Menu
See Section 7.3 on page 44 for information about the
420 Plus
serial data format.
XXXXXXX XXXXXXX XXXXXXX XXXXXXX
EOLDLY
000000
number
EDP PRINT
PRN
EDP
PRNDES
BITS TERMIN BAUD
CR
9600
7ODD
7EVEN
8NONE CR/LF
4800
2400
1200
600
300
Same as EDP
EDP
OFF
STREAM
PRN
ALGOUT DIGIN SETPNT PROGRM PFORMT SERIAL CALIBR CONFIG FORMAT
ECHO
ON
OFF
VERS
19200
38400
2 STOP
1 STOP
S BITS
BOTH
BOTH
LFT
INDUST
STRRTE
ON
OFF
PRNMSG
Figure 3-8. Serial Menu
SERIAL Menu
Parameter Choices Description
Level 2 submenus
EDP BAUD
BITS
TERMIN
EOLDLY
ECHO Specifies settings for baud rate, data bits, termination characters, end-of-line delay and echo
used by the EDP port.
PRINT BAUD
BITS
TERMIN
EOLDLY
ECHO Specifies settings for baud rate, data bits, termination characters, end-of-line delay and echo
used by the printer port.
STREAM OFF
EDP
PRN
BOTH Selects the serial port used for continuous transmission. Streaming can be set for the EDP port,
Printer port, or both ports simultaneously. See Section 7.3 on page 44 for information about the
420 Plus continuous data format.
STRRTE INDUST
LFT Specifies stream rate. Stream rate can be set to industrial or legal for trade.
PRNDES EDP
PRN
BOTH Print destination. Selects the EDP port, printer port, or both ports simultaneously for data
transmission when the PRINT key is pressed or the KPRINT EDP command is sent.
PRNMSG OFF
ON Print message. Default will be OFF. When the print key is pressed and data is sent out, the word
PRINT is momentarily displayed on the remote display.
Level 3 Submenus EDP Port and Printer Port
BAUD 9600
300
600
1200
2400
4800
19200
38400 Baud rate. Selects the transmission speed for the EDP or printer port.
BITS 8NONE
7EVEN
7ODD Selects number of data bits and parity of data transmitted from the EDP or printer port.
Table 3-5. Serial Menu Parameters