beautypg.com

Driv ing and parking, Driving tips – Mercedes-Benz C-Sedan 2015 Owners Manual User Manual

Page 183

background image

Wet roads

If you have driven for a long time in heavy rain

without braking, there may be a delayed reac-

tion from the brakes when braking for the first

time. This may also occur after the vehicle has

been washed or driven through deep water.
You have to depress the brake pedal more

firmly. Maintain a greater distance from the

vehicle in front.
After driving on a wet road or having the vehi-

cle washed, brake firmly while paying atten-

tion to the traffic conditions. This will warm up

the brake discs, thereby drying them more

quickly and protecting them against corro-

sion.

Limited braking performance on salt-

treated roads

If you drive on salted roads, a layer of salt

residue may form on the brake discs and

brake pads. This can result in a significantly

longer braking distance.

R

In order to prevent any salt build-up, apply

the brakes occasionally while paying atten-

tion to the traffic conditions.

R

Carefully depress the brake pedal and the

beginning and end of a journey.

R

Maintain a greater distance to the vehicle

ahead.

Servicing the brakes
!

If the red brake warning lamp lights up in

the instrument cluster and you hear a warn-

ing tone while the engine is running, the

brake fluid level may be too low. Observe

additional warning messages in the multi-

function display.
The brake fluid level may be too low due to

brake pad wear or leaking brake lines.
Have the brake system checked immedi-

ately. This work should be carried out at a

qualified specialist workshop.

!

A function or performance test should

only be carried out on a 2-axle dynamom-

eter. If you wish to operate the vehicle on

such a dynamometer, please consult an

authorized Mercedes-Benz Center in

advance. You could otherwise damage the

drive train or the brake system.

!

The ESP

®

system operates automatically.

The engine and the ignition must therefore

be switched off (the SmartKey must be in

position 0 or 1 in the ignition lock or the

Start/Stop button must be in position 0 or

1) if the electric parking brake is tested on

a brake dynamometer.
Braking triggered automatically by ESP

®

may cause severe damage to the brake

system.

All checks and maintenance work on the

brake system must be carried out at a quali-

fied specialist workshop. Consult a qualified

specialist workshop to arrange this.
Have brake pads installed and brake fluid

replaced at a qualified specialist workshop.
If the brake system has only been subject to

moderate loads, you should test the function-

ality of your brakes at regular intervals.
Information on BAS (Brake Assist) (

Y

page 67)

and BAS PLUS (Brake Assist PLUS)

(

Y

page 67).

For safety reasons, Mercedes-Benz recom-

mends only installing the following brake

disks and brake pads/linings:

R

brake disks that have been approved by

Mercedes-Benz

R

brake pads/linings that have been

approved by Mercedes-Benz or that are of

an equivalent standard of quality

Other brake disks or brake pads/linings can

compromise the safety of your vehicle.
Always replace all brake disks and brake

pads/linings on an axle at the same time.

Always install new brake pads/linings when

replacing brake disks.
The vehicle is equipped with lightweight

brake disks to which the wheel assembly with

rim and threaded connection is matched.

Driving tips

181

Driv

ing

and

parking

Z