Losi LOSB9810 - Manual

Losi (LOSB9810) 2400mAh 11.1V LiPo Transmitter Battery
for JR Z1, KoPropo Helios, and Other Radios
of Similar Battery Configuration
User Manual
Safety Precautions:
1. Read all safety precautions prior to use.
2. Always check and ensure polarity during installation or re-installation of
battery into your transmitter.
3. Charge ONLY as a 3-cell (11.1V) lithium battery (LiPo) or may cause fire.
4. Re-charge transmitter battery when transmitter is at 11.1V.
Note: Do not allow battery to drop below 9.6V
5. This battery has protection circuitry that monitors the status of each cell to
ensure safe charging. Charge only with a LOSB9603, LOSB9605 or Dynamite
DYN4058 LiPo charger. Cell balance is maintained only when used with a
balancing charger such as LOSB9605.
6. Do not use the internal radio charge circuit or connection; remove the
battery for charging and follow charging instructions.
Charging the LOSB9810 Transmitter Battery:
1. Read all safety precautions prior to charging.
2. There are two different connectors (see picture below).
a. White connector is used for Balance Charge the 3-cell LiPo battery.
b. The Red (darker above) is the Primary Charge/Discharge connector.
3. Set your LiPo charger to the 3-cell position for 11.1V, and no more than 2.4A
for the charge rate. Do not charge at more than 1C charge rate (2.4A for
LOSB9810 which is 2400mAh for the battery). Exceeding this may cause the
product to ignite.