Losi LOSB9594 User Manual

Page 4

Warnings:

Continued

Rubber tires can cause severe injury if there is a failure while running

the vehicle while on a stand or when being held. Ensure Rubber tires
are securely mounted and if not re-glue them and check them often
for potential failure.

• Disconnect the battery from the ESC after use.
• Electronic Speed Control (ESC) is not waterproof and should not be exposed

to moisture.

• Do not attempt to use with more than 2-cell LiPo, or six cells NiMH; doing so

will damage the ESC and could result in a fire.

• Mount ESC securely for use.
• Avoid over-tightening of the motor screws. Damaged threads are not covered

under warranty.

Electronic Speed Control Setup:

1. Please read all safety precautions prior to use.
2. Ensure installation is complete and all connectors checked for polarity, ready

for use.

3. Battery is charged and operational.
4. Set the Throttle and Brake throw on your transmitter to 100% (if they are

adjustable).

5. Set the Trim to the centered position.
6. Ensure that the Throttle channel is in the “normal” position and not “reverse”.

If in reverse when you perform step 8, the LED will stay RED until you set to
“normal”.

7. Turn the ESC power switch ON, the Green LED is on solid.
8. Locate the SETUP button on the ESC, press until the RED LED is ON solid.
9. Pull throttle trigger to the full throttle position, the Red LED will be flashing

and then Green LED turns ON solid.

10. Now push the throttle trigger to full brake, the Green LED is flashing, and

then Green and Red LEDs both turn on solid.

11. Release throttle to neutral position. The Green and Red LEDs are flashing,

and then will both be ON solid.

12. Turn off the ESC power switch; this saves the calibration to the ESC. You

have calibrated the ESC for your transmitter.

Note: Should you change transmitters or receivers you must

repeat the above steps to re-calibrate the ESC.

Instructions for Losi Xcelorin 36

Electronic Speed Control / Motor

Page 4 of 8