Losi LOSB9530 - Manual (Page 4)

Electronic Speed Control Setup:
1. Please read all safety precautions prior to use.
2. Ensure installation is complete and all connectors checked for polarity, ready
for use.
3. Battery is charged and operational.
4. Set the Throttle and Brake throw on your transmitter to 100% (if they are
adjustable).
5. Set the Trim to the centered position.
6. Ensure that the Throttle channel is in the “normal” position and not “reverse”.
If in reverse when you perform step 8, the LED will stay Green until you set
to “normal”.
7. Turn the ESC power switch OFF 。
8. Locate the SETUP button on the ESC, press SETUP button, turn the ESC
power switch to ON and hold SETUP button until the Green LED is ON solid.
9. Pull throttle trigger to the full throttle position, the Green LED will be flashing
and then Blue LED turns ON solid.
10. Now push the throttle trigger to full brake, the blue LED is flashing, and then
Green and Blue LEDs both turn on solid.
11. Release throttle to neutral position. The Green and Blue LEDs are flashing,
and then will both be ON solid.
12. Turn off the ESC power switch; this saves the calibration to the ESC. You
have calibrated the ESC for your transmitter.
Note: Should you change transmitters or receivers you must
repeat the above steps to re-calibrate the ESC.
Instructions for Losi Xcelorin 36 th Electronic Speed Control Page 4 of 8