Kontron VMP1 - Manual (Page 5)

VMP1 Preface
ID 19972, Rev. 0101 Page 0 - 5 ® PEP Modular Computers GmbH
Chapter
3
Installation
....................................................................................................3 - 3
3.1 Board Installation ...........................................................................................3 - 3
3.1.1 Front Panel I/O Connectors ......................................................................3 - 4
Chapter
4
Configuration
.............................................................................................4 - 3
4.1 Jumper Settings .............................................................................................4 - 3
4.1.1 Bootstrap Loader / Socket Jumper J1 ......................................................4 - 3
4.1.2 RTC (Real-time clock) Calibration Output J2 ...........................................4 - 3
4.1.3 Resistor Setting for Non-standard Socket Devices ...................................4 - 4
4.1.4 RS485 Termination (Onboard Interface Only)...........................................4 - 4
4.2 Pinouts ..........................................................................................................4 - 5
4.2.1 Flash Socket Type Selection ....................................................................4 - 5
4.2.1.1 Socket Device Selection .......................................................................4 - 5
4.2.2 Serial Interface Expansion Connector CON3 ...........................................4 - 6
4.3 Board Address Map .......................................................................................4 - 7
4.3.1 Address Map Overview ............................................................................4 - 7
4.3.2 VME Address Area....................................................................................4 - 8
4.3.3 Onboard Device Addresses ......................................................................4 - 9
4.3.4 Special Registers Overview ................................................................... 4 - 10
4.3.4.1 Board Control Registers .....................................................................4 - 10
4.3.4.2 Board ID Register ...............................................................................4 - 10
4.3.4.3 Software Compatibility ID ................................................................... 4 - 10
4.3.4.4 Memory Configuration Register .........................................................4 - 11
4.3.4.5 SDRAM Size ...................................................................................... 4 - 11
4.3.4.6 Flash Bank Select Register ................................................................4 - 11
4.3.4.7 Watchdog Control Register ................................................................4 - 12
4.3.4.8 Watchdog Timeout Time ....................................................................4 - 12