Head anchor fabrication, Step #20 detail #19, Step #21 – EFCO 955 Series User Manual

Page 22: Detail #18, Fabrication setting block, Step #19

STEP #20

Detail #19

1/2 SIZE

HN13

SET THE BLOCK IN.

SETTING CHAIR TO

SILICONE TO THE

APPLY A SMALL
AMOUNT OF

4.000"

blocks are required per daylight opening. See detail #19 below for fabrication.

Cut and fabricate the setting blocks from #1918 extrusions. Two (2) setting

Install one (1) #HN13 to the top of #1918 for use with 1G73 intermediate horizontal.

STEP #21

3.000"

1.000"

1.500"

.500"

FS97

Detail #18

1/2 SIZE

5/16" x 13/16"
SLOT

Cut and fabricate the head anchors from #8695 as shown in detail #18

FABRICATED PACKAGE IS AVAILABLE.

K196 FOR 1G73

HEAD ANCHOR FABRICATION

SECTION IV - FABRICATION

FABRICATION

SETTING BLOCK

below.

STEP #19

PAGE #20

{FS97 - FABRICATED PART}

CONT.

BAB 3/2001