Detex Delayed Egress With Magnetic Lock - Manual (Page 7)

R
Catalog No: 94 Security screws
p/n: 102212-1
Double Door Strike Kit
p/n: 101867
Catalog No: KS
Key Stop Kit
(Momentary Shunt)
Key Stop Screw
Security Pin TORX Bits provided
p/n: 101233
Security Screws
Tamper Kit
Catalog No: SSK3
(Security Kit)
Optional Accessories
Make sure the key cylinder arming switch is set to 'OFF'.
Confirm strike is pushing in dead latch, door must be closed.
Confirm 24VDC power on the delayed egress device main board terminals 1(+) & 2(-).
Confirm closed fire loop connection on power supply.
Confirm the two black wires on the center case are plugged into the 2-pin header on
the center case circuit board.
Confirm cable is plugged in properly.
Confirm the mortise cylinder is functioning correctly.
Confirm closed fire loop connection on power supply.
Confirm 24VDC power on the delayed egress device main board terminals 1(+) & 2(-).
With the unit armed there should be 30-38VDC without load on the orange (+) and
blue (-) wires.
The armature plate needs to float. See mag-lock instructions.
The orange wire needs to be wired to terminal 1 in the mag-lock. The blue wire
needs to be wired to terminal 3 in the maglock.
Factory installed jumper removed from terminals 3 & 4.
Check battery. If no battery is needed, slide DisLoBat switch on delayed egress main
board to 'ON'. See electrical pages of instructions.
Alarm sounds immediately
when power is applied:
No green light when key is turned CCW:
No delayed egress:
No magnetic lock engagement,
both red and green lights on:
Low battery signal-
Two chirps every 45 seconds:
Problem
TROUBLESHOOTING
Probable cause
Dogging Lever Assembly
(shown for reference ONLY)
The following models in the series were evaluated by UL: Controlled Exit Panic Devices; Models 10, 20, 21, 30, 40, 50, 51, 60,
61, 62, 63, 70, 71, 80, 81, 82, 83, F10, F20, F21, F30, F40, F50, F51, F60, F61, F62, F63, F70, F71, F80, F81, F82 & F83.
Refer to U.L. listing files for additional information.
104878 Page 7