Cabletron Systems Smart 04-0053-01 - Manual (Page 123)

SmartSwitch ATM User Guide A-7
Agent Support Managing an ATM SmartSwitch
- p2mpRoot
- p2mpLeaf
• atmVplReceiveTrafficDescrIndex — Doesn’t accept ABR traffic descriptor
• atmVplTransmitTrafficDescrIndex — Doesn’t accept ABR traffic descriptor
Not Supported
The following MIB objects are not supported. If used, these objects return either the value zero or the message, “Not
supported.”
• atmInterfaceDs3PlcpTable
• atmInterfaceTCTable
• atmSvcVpCrossConnectTable
• atmSigSupportTable
• atmSigDescrParamTable
• atmIfAdminAddrTable
• atmVclAddrBindTable
• atmAddrVclTable
• atmVclGenTable
• atmfMyOsiNmNsapAddress
• lecRouteDescrTable
• leRDArpTable
A.2 MANAGING AN ATM SMARTSWITCH
Your ATM SmartSwitch must be IP reachable by the NMS before it can be managed. The default connection between
the ATM SmartSwitch and the NMS is the Ethernet interface of the ATM SmartSwitch. Use the
show switchconfig
command to find the IP address of the ATM SmartSwitch. An NMS can use this IP address to reach the ATM
SmartSwitch through Ethernet. An NMS can also manage an ATM SmartSwitch through one of its ATM ports if the
ATM SmartSwitch has a client connection into a VLAN or emulated LAN.
Note that the ATM SmartSwitch itself, is not reachable through ATM until a client for the switch is created and
participates as a member of a VLAN or ELAN. Your NMS uses that switch client’s address to access and manage the
switch.
To create a client for the switch, use the add ipatmclient command for VLANs and add laneclient for emulated
LANs.
Use the set mynmaddr command to tell the ATM SmartSwitch which interface to use when communicating with your
NMS. For detailed information about these commands, see the SmartSwitch ATM Reference Manual.
A.2.1 Console Commands that Affect the Agent
The following is a list of the console commands that affect the operation of the ATM SmartSwitch SNMP agent. For
detailed descriptions of these commands, see the SmartSwitch ATM Reference Manual.