Setting up the dvr unit, Installing the hard disk, 4 setting up the dvr unit – AVer MXR6008 User Manual
Page 9: 1 installing the hard disk
3
1.4
Setting Up the DVR Unit
1.4.1 Installing the Hard Disk
i
For hard disk spec, please referring
→ Pure NVR →
AVerDiGi MXR6004/6008 Mini → Hardware Recommendations
The “compatible hard disks” indicated in the above recommendation list only means that these
commercially available hard disks were tested with AVerMedia products and functioned well under
normal operation conditions. AVerMedia does not guarantee or provide warranties, explicitly, implied or
statutory with respect to the reliability of the hard disk function or its compatibility. In no event
AVerMedia shall be liable for damages, with respect to any business interruption of clients, lost profits,
loss of programs or other data on your information handling system or otherwise. This includes direct,
indirect, incidental, special, or consequential damages, resulting from the incompatibility caused by the
usage of these hard disks, even if AVerMedia has expressly advised about the risk of such damages.
The entire risk arising out of the use of any information attached here with is borne by the recipient.
The DVR unit allows user to install one hard disk. Follow the illustrated instructions below to
install the hard disk:
1. Loosen all screws
2. Push the cover backward and lift
3. Secure the HDD holder on the hard disk. The
position to screw the HDD holder on hard disk must
same as figure shown. Otherwise, the hard disk
won
’t be able to fit into inside the DVR unit.
4. Connect the SATA cable and the power connector to
the hard disk