AVer MOB1304 - Manual (Page 47)

41
OSD MENU Description
EVENT SETUP
ALARM SETTING
SENSOR SETTING
MOTION DETECTION
TEMPERATURE
SHOCK DETECTION
VOLTAGE
MOTION DECTECION
MOTION DETECTION SETUP
SENSTIVITY
ENABLE
CH1 CH2 CH3 CH4
5 5 5 5
MASK SETUP
ENABLE
Enable/disable the channel to detect motion.
SENSITIVITY
Set the sensitivity level. The sensitivity is from HI (High), 9~ 2 and LO
(Low).
MASK SETUP
Select a specific area for motion detecting. The DVR system will start
recording when the selected area has been detected motion and the
MOTION DETECTION has been enabled in ALARM SETTING.
EVENT SETUP
ALARM SETTING
SENSOR SETTING
MOTION DETECTION
TEMPERATURE
SHOCK DETECTION
VOLTAGE
TEMPERATURE
FAN ON
FAN OFF
TEMPERATURE SETUP
TEMP. TYPE
ALARM THRESHOLD
050
040
060/005
HDD STOP 070/005
RESET TO DEFAULT
C
TEMP. TYPE
Temperature pattern display on front LCM panel.
FAN ON
Set a specific temperature limit for fan active. When the hard disk
temperature reaches temperature limit, the fan will be active.
FAN OFF
Set a specific temperature limit for fan stop. When the hard disk
temperature reaches temperature limit, the fan will be stop.