AVer MOB1304 User Manual

Page 45

OSD MENU

Description

MAIN MENU

CAMERA/REC

SCHEDULE
EVENT SETUP

DISPLAY

STORAGE

NETWORK

SYSTEM
MISCELLANEOUS

EVENT SETUP

Configure alarm, sensor, motion, temperature, shock, and voltage.

EVENT SETUP

ALARM SETTING
SENSOR SETTING
MOTION DETECTION
TEMPERATURE
SHOCK DETECTION
VOLTAGE

ALARM SETTING

Configure parameters of alarm.

ALARM CONTINUOUSLY

ALARM PERIOD

ALARM TYPE

SELECT / DESELECT ALL
SENSOR

RECORD

MOTION DETECTION
TEMPERATURE

VIDEO LOSS

VOLTAGE

SHOCK DETECTION

REMOTE TRIGGER

HDD FAIL
FAN FAIL

005 SEC

ALARM SETUP

ALARM TYPE

Select the way of alarming

– REC, EMAIL, GSM, BUZZER, or

RELAY.

ALARM PERIOD

Set the amount of time (in seconds) to sending the alarm once
triggered.

ALARM CONTINUOUSLY

Enable/disable the alarm event continuously to display on the spot
monitor until the next alarm event is coming in.

SELECT/DESECLECT ALL

To enable/disable all below selection.

SENSOR

Enable/disable to send out the alarm if sensor has been triggered
according to the setting of SENSOR SETTING.

MOTION DETECTION

Enable/disable to send out the alarm if motion has been detected
according to the setting of MOTION DETECTION.

TEMPERATURE

Enable/disable to send out the alarm when temperature has
exceeded the limit that user has setup.

SHOCK DETECTION

Enable/disable to send out the alarm when MEMS has exceeded the
range that user has setup in SHOCK SETUP.

VOLTAGE

Enable/disable to send out the alarm when 12V VOLTAGE and RTC
DETECTION has been enabled in VOLTAGE SETUP.