Turn the command dial to < a-dep, Focus the subject, Check the viewfinder display and take the picture – Canon Rebel Ti 300V User Manual

Page 43: A’dep :automatic depth-of-field ae, A-dep

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

A’DEP :Automatic Depth-of-Field AE

This mode is for obtaining a wide depth of field automatically between a

near subject and far subject. It is effective for group photos and landscapes.

The camera uses the 7 AF points to detect the nearest and farthest sub

jects to be in focus.

* “A-DEP” stands for Auto-depth of field.

Turn the Command Dial to <

A-DEP:

Focus the subject.
• Move the AF point over the subject

and press the shutter button halfway.

• All the subjects covered by the AF

points which flashed in red will be in

focus.

• If you press the depth-of-field preview

button while the exposure reading is

displayed in the viewfinder, you can
see the depth of field, (^page 41)

es 8,0

The < A-DEP > mode cannot be used if the lens' focus mode switch is set to

(or on older lenses).

' If the aperture blinks, it indicates that the exposure level is correct but the

desired depth of field cannot be achieved. Either use a wide-angle lens or
move further away from the subjects.

’ In this shooting mode, you cannot freely change the shutter speed and

aperture. If the camera sets a slow shutter speed, hold the camera steady
or use a tripod.

If flash Is used, the result will be the same as using flash in the <

> mode.

Check the viewfinder display and

take the picture.

• In the example above, the focus will

be sharp between the front person on

the left and the rear person on the

right.