Canon Rebel Ti 300V - Manual (Page 18)

© Loading and Unloading Film
Loading Film
After you load the film, the camera first winds the entire roll onto the
camera’s take-up spool. With DX-coded film, the camera automatically
sets the film’s ISO speed. Then each time a picture is taken, one frame
of film is rewound back into the film cartridge. The frame counter shows
always number of shots remaining.
Right
4 Turn the Command Dial to any
* setting except
"y Open the back cover.
^ • Slide the back cover release lever as
shown by the arrow.
> Insert the film cartridge at an
^ angle as shown in the illustration.
A Align the edge of the film with the
'^orange
< A>
index mark.
• Hold down the film cartridge while
pulling out the film leader.
• If the edge of the film leader goes
beyond the orange mark, rewind some
of the film back into the cartridge.
Close the back cover.
• Check that the edge of the film is
aligned with the < A > mark, then close
the back cover until it snaps shut.
► After you close the back cover, the
film will start winding on the take-up
spool and the frame counter will
count up. The camera will then make
a shutter-release sound and the
<@> icon and total frame count will
be displayed.
► During the film's prewind, the ISO
speed is displayed on the LCD panel.
18