Insert the battery pack in the adapter as shown, Plug the adapter into a mains outlet, Wait until the battery pack is fully charged – Canon E 700 User Manual

Page 12: Detach the battery pack after use

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Charging and attaching the battery pack

You will have to charge the battery pack before you
can use it. A brand new battery pack must be
charged twice before use.
Use the CA-100 Compact Power Adapter.

B P-E77K B attery P ack

I Charging time:

70 minutes

Continuous recording time: 50 minutes

These times vary — the safest policy is to
always have two or three times as many battery

I packs as you think you will need.

1. Insert the battery pack in the adapter as

shown.

• Make sure the DC coupler is not connected.

2. Plug the adapter into a mains outlet.

• The green OPERATE indicator lights up.
• The red CHARGE indicator flashes to show

that charging is in progress.

3. Wait until the battery pack is fully

charged.
• The CHARGE indicator glows steadily when

the battery pack is fully charged.

4. If the battery pack is brand new, remove

it from the adapter, then insert it again
and charge it one more time.

5. Remove the battery pack from the

adapter and attach it to the camera.
• Slide it in, then press it until it clicks and locks

into place.

6. Detach the battery pack after use.

• Slide and hold the ВАТТ EJECT lever while

you pull the battery pack outwards from the
front.

• Always turn the camera off before removing

the power source.

tf>

5‘