Shooting on manual, Controls detail, Continued – Nikon fe2 User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONTROLS
DETAIL —
‘Continued
M
B
Shooting on manual
1) Turn the shutter speed/mode selector dial to any of sixteen
numbered settings or set the f/stop you desire. Faster shutter
speeds will freeze moving subjects while slower ones cause
the action to blur. (Note that you cannot use the shutter
speed/mode selector dial in between the indicated settings.)
2) While looking through the viewfinder, place the subject in the
center of the frame; then pull out the film advance lever,
depress the shutter release button halfway, and check both
the black meter needle and green shutter speed/mode
indicator needle.
3) If both are apart, to get the correct exposure, rotate the
aperture ring and/or the shutter speed dial so that they are
aligned.
4) Depress the shutter release button all the way to take the
picture.
Notes:
1) Because the aperture ring can be set in between the engraved
f-numbers. slight adjustment to obtain the correct exposure should be
made by turning the aperture ring of the lens.
2) At the mechanical settings of M250 and B, the meter does not function
and the meter needle will not move.
3) If you wish to create intentional under- or overexposure, set either
the aperture ring or shutter speed/mode selector dial so that both
needles In the viewfinder are not aligned.
26