Cabletron Systems EMM-E6 Ethernet - Manual (Page 75)

CHAPTER 3: INSTALLATION
3-14 EMM-E6 User’s Guide
4. Firmly press the module connections into the backplane. Do not try to
force the module into place or use the knurled knobs to draw the
module into the backplane. Forcing a misaligned module into place
can damage the EMM-E6 or the MMAC backplane.
Figure 3-7. Installing the EMM-E6
5. Secure the module to the MMAC chassis by tightening the knurled
knobs. If you do not tighten the knurled knobs, vibration can cause
the module to lose contact with the backplane and disrupt your
network.
7. Re-install the MMAC chassis safety bars.
6. Power-up the MMAC (if it isn’t already ON).
EMM-E6
Chassis Slots 1 and 2 Knurled Knobs
EMM-E6 MMAC M8FNB
It takes several minutes for the EMM-E6 to boot up. While
booting, the EMM-E6 displays boot-up diagnostics on Local
Management. Refer to Chapters 4 and 5 for additional
information on how to connect and configure a Local
Management console.
NOTE
CH1Book Page 14 Wednesday, March 20, 1996 7:48 AM