Cabletron Systems EMM-E6 Ethernet User Manual

Page 14

CHAPTER 1:

INTRODUCTION

1-2

EMM-E6 User’s Guide

Chapter 5,

Accessing Local Management

, describes how to access LM

after you attach the management console.

Chapter 6,

Community Names

, explains how to use the Community

Name Table screen to set both local and remote access levels.

Chapter 7,

Configuration Screen

, describes how to assign IP addresses,

subnet masks, and the default gateway to the EMM-E6. This chapter also
explains how to enable and disable all ports.

Chapter 8,

Trap Table Screen

, explains how to designate management

stations as recipients of SNMP alarm or event traps.

Chapter 9,

SNMP Tools Screen

, provides information on the resident

EMM-E6 Management Information Base (MIB) walking tool.

Chapter 10,

Router Setup Screen

, Shows the Routing Services Setup

Screen, where the EMM-E6’s optional Routing Services may be
accessed.

Chapter 11,

Device Statistics Screen

, illustrates the statistics provided by

EMM-E6/LM. This chapter also describes how to enable and disable
specific ports on the EMM-E6, and set the statistics update frequency
time.

Chapter 12,

Command Line Interface Screen

, shows the Command

Line Interface (CLI) screen. This screen will function in future releases of
EMM-E6 firmware.

Chapter 13,

MIB Navigator

, provides instructions and examples for

using the navigator command set.

Chapter 14,

Troubleshooting

, details the EMM-E6 LANVIEW



LEDs

that enable you to quickly diagnose network/operational problems and
provides suggested courses of action for troubleshooting.