Cabletron Systems EMM-E6 Ethernet - Manual (Page 70)

ADDING/REPLACING EPIMs
EMM-E6 User’s Guide 3-9
3.4 ADDING/REPLACING EPIMs
This section contains procedures on how to add/replace an Ethernet Port
Interface Module (EPIM) to upgrade or change the capabilities of your
hub. After installing your new EPIM, refer to appropriate EPIM sections
in this chapter to verify proper operation.
To install an EPIM:
1. Remove the coverplate or the EPIM (whichever applies).
2. Slide your new EPIM into place, making sure the connectors on the
rear of the module and inside the hub attach properly.
3. Install the mounting screw.
Figure 3-4. Installing an EPIM
Observe all anti-static precautions when handling
sensitive electronic equipment.
!
CAUTION
When removing an EPIM, make sure to pull the module
straight out so as not to damage the connector.
NOTE
EPIM-A
PWR
STBY
RCV
XMT
CLN
E
P
I
M
1
E
P
I
M
2
E
SR LNK TS TST
SYNC
BRIM-W2
B
TWR
WRP RCV
XMT
LNK
EMM-E6
EPIM
Mounting
Screw
CH1Book Page 9 Wednesday, March 20, 1996 7:48 AM