Cabletron Systems EMM-E6 Ethernet - Manual (Page 113)

CONFIGURING THE TRAP TABLE
EMM-E6 User’s Guide 8-3
6. Using the arrow keys, highlight the desired Trap IP Address field.
7. Enter the IP address of the workstation to which you want the
EMM-E6 to send traps. Use the XXX.XXX.XXX.XXX format with
the value of XXX ranging from 0 to 254.
8. Using the arrow keys, highlight the SAVE command.
9. Press the Return key. The message “SAVED OK” appears.
10. Exit the screen by either pressing the appropriate Function key to go
directly to the desired LM screen, or by using the arrow keys to
highlight the desired LM screen or the RETURN command, and then
pressing the Return key. Using the RETURN command takes you
back to the Feature Selection Screen.
The designated workstations, if properly configured and utilizing SNMP
compliant remote management software, will now receive SNMP traps
from the EMM-E6.
If you exit without saving, you lose all edits.
NOTE
CH1Book Page 3 Wednesday, March 20, 1996 7:48 AM