Cabletron Systems EMM-E6 Ethernet - Manual (Page 152)

USING THE RESET SWITCH
EMM-E6 User’s Guide 14-7
14.3 USING THE RESET SWITCH
The EMM-E6 incorporates a recessed reset switch, located above the
LEDs (see Figure 14-1). This reset switch initializes the EMM-E6
processor. This switch does NOT initialize Non-Volatile Random Access
Memory (NVRAM), the non-volatile random access memory where the
EMM-E6 stores network management parameters.
To use the reset switch, use a pen or pencil to press the switch in. When
this is done, the EMM-E6 initializes itself.
CH1Book Page 7 Wednesday, March 20, 1996 7:48 AM