Sony CCD-FX510 - Manual (Page 74)

If an indicator blinks in the viewfinder screen and the display window or a caution lamp on the mam unit
blinks, check the following table.
slow blinking
L
fast blinking
Symptom
Cause Corrective actions
Viewfinder Display window
Camera or
VTR
operation
CP
CJ
The battery is weak. Prepare a charged one.
Battery lamp
CP
CD
The battery is used up. Use a charged battery
Battery lamp
Camera
operation
* eSB ii
*
QK3 ±
The tape is at its end. Use a new tape.
* Battery lamp
E3!g
0!S
The tape is near its end. Prepare a new one.
Battery lamp
No tape is inserted. Insert a tape.
it 0!(3 ±
The tab on the tape is out
(red).
Slide the tab.
Camera or
VTR
operation
♦
GDor^
m
ISor±
Moisture condensation
has occurred. Remove the tape and
leave the camcorder for
at least an hour.
e
—
The gap of the head is
clogged. Clean the head using
the Sony V8-25CLH
video head cleaning
tape.
Caution lamp
♦
A
Other troubles may
occur. Consult your rrearest
Sony dealer.
* Caution lamp
^ blinks for
five seconds
after setting the
POWER switch
to CAMERA.
—
The lithium battery is not
installed.
The lithium battery is
exhausted.
The lithium battery is
weak.
Install a lithium battery
with the battery pack or
other power source
attached. Otherwise,
you must readjust
the date, time and
birth dates.
* In these cases the displayed indicator is accompanied by a series of beeps when the BEEP
switch is turned on.
74
Additional
Information