Charging and installing the battery pack, Important – Sony CCD-FX510 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Chapter 1: Getting Started
Charging and Installing the Battery Pack
Before you can use your camcorder, you need to charge and install the battery pack.
Charging the Battery Pack
1 Plug the AC power adaptor into a wall outlet.
2 Attach the battery pack to the AC power adaptor.
— Align the side of the battery pack with the white line on the AC power adaptor.
— Push the battery pack down and slide it in the direction of the arrow.
3 Set the CHARGE/VTR switch on the AC adaptor to CHARGE.
When charging is completed, the charge indicator on the AC adaptor goes out.
Required charging time:
Type of battery pack
NP-55H
(supplied)
NP-77H/
NP-77HD
NP-77
NP-66H
NP-55
Required charging time
80
160
140
120
70
(approx time in minutes using AC-V25Si
Important!
Use the battery completely before charging!
Before you recharge the battery, make sure the battery has been used (discharged)
completely to avoid reducing the capacity of the battery caused by excessive charging.
To use up the battery, remove the video cassette and simply slide the POWER switch to
CAMERA with the battery attached, and leave the camcorder until the
appears blinking and a red lamp blinks in the viewfinder.
0 Getting Started