Set the power switch on the camcorder as follows, Using the remote commander – Sony CCD-FX510 User Manual

Page 21

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Using the Remote Commander

Using the Remote Commander, you can be in the picture with your friends and family

while recording, or conveniently control the playback of your tape from a distance.

Insert two size AA (R6) batteries with

correct polarity.

Set the a REMOTE COMMANDER
switch on the battery mounting surface
of the camcorder to ON.

If the battery is attached, remove it.
Reattach the battery after setting the
REMOTE COMMANDER switch.

REMOTE |3BSn

COMMANDER 13199

OFFI ION

Set the POWER switch on the camcorder as follows:

— When camera recording, 1) press the small green button on the POWER switch

and slide it to CAMERA, 2) set the STANDBY switch up.

— When playing back, set the POWER switch to VTR.

Aim the Remote Commander at the remote sensor of the camcorder and

press the appropriate button on the Commander.

Remote sensor

2 m (6.6 ft)'

(Approximate maximum distance and angles for remote

control)

Notes on the Remote Commander

• Do not use the remote sensor in a strongly lighted room, since it may not work properly

under such condition.

« The command mode of the Commander is VTR2. Avoid using a Sony VCR with the

same command mode at the same time.

Basic Camera Operation