Dell PowerVault DL2000 User Manual
Page 151
Troubleshooting Your System
151
3 Open the system. See "Opening and Closing the System" on page 66.
4 Ensure that each processor and heat sink are properly installed. See
5 Close the system. See "Opening and Closing the System" on page 66.
6 Reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
7 Run the appropriate online diagnostic test.
If the tests fail or the problem persists, continue to the next step.
8 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
9 Open the system. See "Opening and Closing the System" on page 66.
10 Remove processor 2, leaving only processor 1 installed. See "Processors" on
page 105.
To locate the processors, see Figure 6-2.
If only one processor is installed, see "Getting Help" on page 167.
11 Close the system. See "Opening and Closing the System" on page 66.
12 Reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
13 Run the appropriate online diagnostic test.
If the tests complete successfully, go to step 19.
14 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
15 Open the system. See "Opening and Closing the System" on page 66.
16 Replace processor 1 with another processor of the same capacity. See
17 Close the system. See "Opening and Closing the System" on page 66.
18 Run the appropriate online diagnostic test.
If the tests complete successfully, replace processor 1. See "Getting Help"
on page 167.
19 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
Book.book Page 151 Monday, September 14, 2009 12:57 PM