Dell PowerVault DL2000 - Manual (Page 135)

Troubleshooting Your System
135
Action
1 Enter the System Setup program, and ensure that the USB ports are
enabled. See "Using the System Setup Program" on page 45.
2 Turn off the system and any USB devices.
3 Disconnect the USB devices, and connect the malfunctioning device to
the other USB connector.
4 Turn on the system and the reconnected device.
If the problem is resolved, the USB connector might be defective. See
"Getting Help" on page 167.
5 If possible, swap the interface cable with a working cable.
If the problem is resolved, replace the interface cable. See "Getting Help"
on page 167.
6 Turn off the system and the USB device, and swap the device with a
comparable device.
7 Turn on the system and the USB device.
If the problem is resolved, replace the USB device. See "Getting Help" on
page 167.
If the problem persists, see "Getting Help" on page 167.
Book.book Page 135 Monday, September 14, 2009 12:57 PM