Dell 2355dn Multifunction Mono Laser Printer - Manual (Page 193)

192
If you selected TCP/IP (IPv6).
a Press IPv6 Activate.
b Press the left/right arrows to change the setting to On (enable) or Off (disable).
5 Press the home icon ( ) to return to the Standby mode.
Static Addressing
To enter the TCP/IP address from your printer’s operator panel, take the following steps:
1 Press Setup Machine Setup from the home screen.
2 Press the Next ( ) button.
3 Press the up/down arrows to select Network Setup.
4 Press the up/down arrows to select TCP/IP (IPv4).
5 Press the up/down arrows to select Set IP Address.
6 Select Configuration and press the left/right arrows to select Manual.
7 Select the IP Address menu.
An IP address consists of 4 bytes.
8 Press 1st byte area and enter the numbers using the keypad.
Enter the rest of the bytes in the same way.
9 Enter other parameters, such as the Subnet Mask or Gateway.
10 After entering all parameters, press the home icon ( ) to return to the Standby mode.
Dynamic Addressing (BOOTP/DHCP)
To assign the TCP/IP address automatically using a DHCP or BOOTP server on your network.
1 Press Setup Machine Setup from the home screen.
2 Press the Next ( ) button.
3 Press the up/down arrows to select Network Setup.
4 Press the up/down arrows to select TCP/IP (IPv4).
5 Press the up/down arrows to select Set IP Address.
6 Select Configuration and press the left/right arrows to select DHCP.
To assign the address from the BOOTP server, press the left/right arrows to select BOOTP.
Restoring the Network Configuration
You can return the network configuration to its default settings.
1 Press Setup Machine Setup from the home screen.