Dell XPS 600 - Manual (Page 94)

94
Removing and Installing Parts
www
.dell.com | support.dell.com
9 Connect any cables that
should be attached to
the card.
See the documentation
for the card for
information about the
card cable connections.
NOTICE:
To connect a
network cable, first plug the
cable into the network port
or device and then plug the
cable into the computer.
10 Replace the computer
cover, reconnect the computer and devices to electrical outlets, and then turn them on.
11 If you installed a sound card or a network adapter, see "Network Adapter and Sound Card
Settings" on page 94.
12 Install any drivers required for the card as described in the card documentation.
Network Adapter and Sound Card Settings
If you installed a sound card:
1 Enter system setup, select Integrated Audio Controller, and then change the setting to Off.
2 Connect external audio devices to the sound card connectors. Do not connect external audio
devices to the microphone, speaker/headphone, or line-in connectors on the back panel.
If you removed a sound card:
1 Enter system setup, select Integrated Audio Controller, and then change the setting to On.
2 Connect external audio devices to the audio connectors on the back panel of the computer.
If you installed an add-in network adapter and want to disable the integrated network adapter:
1 Enter system setup, select Integrated NIC Controller, and then change the setting to Off.
2 Connect the network cable to the add-in network adapter connectors. Do not connect the
network cable to the integrated connector on the back panel.
If you removed an add-in network connector:
1 Enter system setup, select Integrated NIC Controller, and then change the setting to On.
2 Connect the network cable to the integrated connector on the back panel of the computer.
alignment bar
alignment guide
retention arm
filler bracket