Dell PowerEdge C6145 - Manual (Page 145)

Installing System Components | 145
LSI 9265-8i RAID Battery (Optional)
Removing the LSI 9265-8i RAID Battery Assembly
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
NOTE: The information in this section applies only to systems with the optional
RAID controller card.
1 Recommend to turn off the system, including any attached peripherals,
and disconnect the system from the electrical outlet.
2 Remove the system-board assembly. See “Removing a System-Board
Assembly” on page 115.
3 Disconnect the cable connecting to the LSI 9265-8i card.
4 Remove the two screws securing the LSI 9265-8i RAID battery
assembly to the system-board assembly, and lift the LSI 9265-8i RAID
battery assembly away from the system-board assembly. See Figure 3-
20.