Cable routing for lsi 9260-8i card – Dell PowerEdge C6145 User Manual
Page 133

Installing System Components | 133
8 Holding the card by its edges, position the card so that the card-edge
connector aligns with the expansion-card connector.
9 Insert the card-edge connector firmly into the expansion-card
connector until the card is fully seated.
10 Replace the screw securing the LSI 9260-8i card.
11 Place the LSI 9260-8i card assembly into the system-board assembly.
12 Replace the three screws that secure the LSI 9260-8i card assembly.
13 Install the system-board assembly. See "Installing a System-Board
Cable Routing for LSI 9260-8i Card
1 Connect the mini-SAS&SGPIO cable to the LSI 9260-8i card, and
connect the other end of the cable to the corresponding connectors on
the system board. Make sure the cables should go through the cable
clip ring. See Figure 3-14.
2 Connect the RAID battery cable to the BBU interposer card on the LSI
9260-8i card, and connect the other end of the cable to the
corresponding connector on the RAID battery.
NOTE: When connecting the RAID battery cable, the BBU interposer card
should be installed on the LSI 9260-8i card. The BBU interposer card in the
figure below is just for you reference.