Dell PowerEdge RAID Controller 6E - Manual (Page 109)

Configuring and Managing RAID
109
3 Press to display a menu of available actions.
The Rebuild option is highlighted at the top of the menu.
4 Press the right-arrow key to display the rebuild options and select Start.
5 After you start the rebuild, press to display the previous menu.
NOTE:
You can also use the VD Mgmt screen to perform a manual rebuild. Use the
arrow key to highlight physical disk in the tree view, and press . In the menu
that displays, select the Rebuild option.
CAUTION:
If a physical disk is a member of a disk group that contains multiple
virtual disks and one of the virtual disks is deleted when a rebuild operation is in
progress, the rebuild operation stops. If this occurs, you can resume the rebuild
operation manually using a storage management application. To avoid
interruption, ensure that none of the virtual disks are deleted until the rebuild
is complete.
Controller Management
Enabling Boot Support
NOTE:
See your system documentation to ensure the proper boot order is selected
in the system BIOS.
In a multiple controller environment, you can enable BIOS on multiple
controllers. However, if you want to boot from a specific controller, enable the
BIOS on that controller and disable it on the other controllers. The system
can then boot from the BIOS-enabled controller. Perform the following steps
to enable the controller BIOS:
1 Press to access the Ctrl Mgmt menu screen.
2 Press to move the cursor to Enable Controller BIOS in the
Settings box.
3 Press the spacebar to select Enable Controller BIOS.
An X displays beside Enable Controller BIOS.
4 Press to move the cursor to the Apply button, and then press
to apply the selection.
The controller BIOS is enabled. To disable the controller BIOS, use the
spacebar to de-select the Enable Controller BIOS control, and then select
Apply and press .
Dell_PERC6.2_UG.book Page 109 Wednesday, June 24, 2009 6:08 PM