Dell PERC 4/SI - Manual (Page 61)

10. Select Continue and press .
Updating an Existing Driver for NetWare 5.1 or 6.0
Perform the following steps to update an existing driver for NetWare 5.1 or 6.0:
1. Create a driver diskette.
See Creating a Driver Diskette in the Installing Windows 2000 or 2003 Using the Microsoft Operating System CD with Driver Diskette section for
information. (The procedure for creating a driver diskette is the same for all operating systems.)
2. Once the NetWare server is up, type the following:
nwconfig
3. Press to access the NetWare Configuration Utility.
4. On the Configuration Options screen, select Driver Options and press .
5. Under the Driver Options, select Configure Disk and Storage Options, then press .
6. Under the Additional Driver Actions menu, press the down arrow key to select the Additional Driver option, then press .
7. Press to install an unlisted driver.
8. Press again if using a diskette; otherwise, press to specify a different location.
9. Insert the driver diskette into the diskette drive and press .
The file pedge3.ham displays under the option Select a Driver to Install.
10. Highlight pedge3.ham and press .
11. Select Yes to copy pedge3.ham files to C:\NWSERVER.
12. Select No to save the existing file messages to C:\NWSERVER.
13. Under pedge3 Parameters, perform the following steps to provide the slot number.
14. Press to access System Console.
15. On the System Console, type:
load pedge3
16. Press .
The following supported slot options display:
l No Selection
l PCI Slot_2.1 (HIN 203)
17. Write down the number after "HIN".
In the example in step 16 , it is 203.
18. Under Choice, type:
0
for the option No Selection.
19. Unload pedge3.ham.
20. Press until you exit the System Console and return to the pedge3 Parameters screen in the NetWare Configuration Utility.
NOTE: You must load a driver for each controller. For example, if you have four adapters, the driver is listed four times.