Dell PowerEdge 6850 - Manual (Page 22)

20
SAS Information Update
Figure 1-12. Removing and Installing the Peripheral Interposer Board
Installing a Peripheral Interposer Board
1 Connect the backplane power cable to the front of the interposer board. See Figure 1-11.
2 Install the peripheral interposer board:
a Carefully lower the interposer board into the system, being careful to avoid damaging components
on the face of the board. See Figure 1-12.
b Align the installation alignment slot on the bottom of the interposer board with the alignment pin
on the bottom of the chassis.
c Slide the retention slots on the interposer board over the retention hooks on the chassis.
d Slide the board downward until the blue retention tab snaps into place.
1 retention tab 2 installation alignment slot 3 peripheral interposer board
3
1
2