Edge Lighting Light Channel, Millwork 12V User Manual
Page 2
2
E
6: Drill one end of the slot with 7/32 bit to run the light channel
wire.
7: Feed the wires through the hole and snap the light channel
into the slot, make sure all clips are tight. If necessary slide
the mounting clip to the appropriate area.
8: Follow the instructions provided with the power supply to
power up the light channel.
SLOT
LIGHT CHANNEL
7
MOUNTING PLATE
7
D
POWER CORD
CUT
5
5
LIGHT CHANNEL
5: Cut the other end of the power cord (male or female) and
discard it. Strip the wire end for connecting it to the power
supply.
See also other documents in the category Edge Lighting Lighting:
- Chopper (2 pages)
- Form Round & Square MR16 (2 pages)
- Form Round & Square 2-Head MR16 (2 pages)
- Function Round & Square MR16 (2 pages)
- Harley (2 pages)
- Harley with Gobo (4 pages)
- Low Rider (3 pages)
- Low Rider Spinner (2 pages)
- Rebel (2 pages)
- Spirit (3 pages)
- Triumph (3 pages)
- Vespa (1 page)
- S1 - S3 Shade Accessories (2 pages)
- S5 - S7 Shade Accessories (1 page)
- Adam Pro Aim MR16 (4 pages)
- Box Pro Aim MR16 (4 pages)
- Neo Pro Aim MR16 (4 pages)
- Phi Pro Aim MR16 (4 pages)
- Alps (4 pages)
- Bloom (3 pages)
- Bubble Ball (4 pages)
- Crossroads (3 pages)
- Crystal Galaxy (4 pages)
- Crystal Galaxy with Downlight (5 pages)
- Crystal Spirit (4 pages)
- Drop 2 Pendant (2 pages)
- Everest (3 pages)
- Ice (3 pages)
- Izar (4 pages)
- Jelly (2 pages)
- K2 LED (2 pages)
- King's Crossing (4 pages)
- LED Pipe (2 pages)
- M&M LED (2 pages)
- Mata Hari 3 (3 pages)
- Outlaw (4 pages)
- Quattro LED (2 pages)
- Scope LED Pendant (3 pages)
- Tower of Crystal Love (4 pages)
- Tower of Love Shattered (4 pages)
- Vase (2 pages)
- Vessel 4 (3 pages)
- Vessel 6 (2 pages)
- White Night & Dark Night (3 pages)
- Zzz Lamp (4 pages)