Edge Lighting Micro Grazer Light Channel 7W or 4.4W 24V User Manual
Micro grazer light channel 7w, 24v, Install the light channel, Installation instructions for

Installation Instructions for
Micro Grazer Light Channel 7W, 24V
904-LCMG7-24V-03
Install the Light Channel
1
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2013 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
- This instruction shows a typical installation.
IMPORTANT INFORMATION
D
3: Tap the anchors onto the marked points up to the threaded
portion with a hammer.
4: Screw in the threaded portion of the anchors with a Phillips
screwdriver.
SURFACE
3
4
ANCHOR
LCMG7-24V-_
2: Place the clips on the surface every 1' (measure from the
the center slot of the mounting clip) and mark the screw
locations.
NOTE:
mounting the clips to a wood surface directly. ANCHORS ARE
NOT PROVIDED.
Steps 3 to 5 are for drywall mounting. Omit these steps if
C
MOUNTING
CLIP
CEILING
2
2
1FT
1FT
3IN-6IN
TEXTURED WALL
TEXTURED W
ALL
STUD
CEILING
LIGHT
BEAMS
TEXTURED W
ALL ON A
11°
STUD
CEILING
LIGHT
BEAMS
A
1: Choose one of the two options to install the Micro Grazer to
properly graze the textured wall.
Option A: Mount the Micro Grazer 3" to 6" away from
the straight textured wall.
Option B: Mount the Micro Grazer next to the textured wall
that is installed at an 11° angle.
B
E
MOUNTING
CLIP
CEILING
5: Line up the mounting clips to the anchors and secure it to
the anchors by tightening the two #8 screws to each
clip.
#8 SCREW
ANCHOR
5
5
5
TEXTURED WALL