Edge Lighting Flexible T-Connector - Manual

SS-CFXT-3IN
Installation Instructions for Flexible "T" Connector
904-SS-CFXT-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2011 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
IMPORTANT INFORMATION
- These products are ETL Listed for indoor locations.
Installing the Flexible "T" Connector to Soft Strips
A
1:
Flexible "T" connector. Refer to the installation provided to
the installation instruction provided with the Soft Strip to
complete the installation. Simply connect the proper side of the Soft Strip to the
NOTE: The straight ends of the Flexible "T" connector plug into
male ends of the Soft Strips and the perpendicular end plugs into
female end of a Soft Strip. Make sure this fits to the design before
Installing the Soft Strips and Flexible "T" connector.
1
MALE END OF
THE SOFT STRIP
FEMALE END OF
THE SOFT STRIP
FLEXIBLE
T-CONNECTOR
1
1
1
B
Installing the Flexible "T"
Connector to Light Channel
3
LIGHT CHANNEL
POWER END CAP
FLEXIBLE
T-CONNECTOR
3
3
1: For each Light Channel, remove the bottom two screws of
the end that is going to be connected to the Flexible "T"
connector.
2: Place the Flexible "T" connectors ends into the cord grips
(provided with the Light Channel).
3: Push the each Light Channel onto the one end of the Flexible
"T" connector. Tighten the cord grip to the end of the Light
Channels with the two Phillips screws (provided with the cord
grips).
4: Refer to the installation instructions provided with the Light
Channel to complete installation.
1
CORD GRIP
FLEXIBLE
T-CONNECTOR
POWER
END CAP
SCREW
CORD GRIP
1
NOTE: The straight ends of the Flexible "T" connector plug into
male ends of the Light Channels and the perpendicular end plugs
into female end of a Light Channel. Make sure this fits to the
design before Installing the Light Channels and Flexible "T"
connector.
2
SCREW
LIGHT CHANNEL