Edge Lighting SS2P Soft Strip, 2.3W 24VDC High Output - Manual

SS2P-24V-_
Installation Instructions for Premium Soft Strip LED 2 Watt 24 Volt
1
904-SS2P-24V-06
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2012 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
IMPORTANT INFORMATION
Install the Soft Strip
1:
installed. (Do not install it in an enclosed area)
2: For all surfaces other than aluminum, use the provided
aluminum heat sink tape (SS-HR-F) to avoid overheating
which may cause LEDs to fail.
3: Remove the backing from the aluminum heat sink tape
(SS-HR-F) and firmly press it down where the LED soft strip
is going to be mounted.
Clean the area thoroughly where soft strip LED will be
A
1
SURFACE
ALUMINUM HEAT
SINK TAPE (SS-HR-F)
3
2
NOTE: The soft strip LEDs are rated for 40,000 hours when
using the aluminum heat sink tape (SS-HR-F).
NOTE: The adhesive tape of the aluminum heat sink needs to
be affixed on smooth clean surfaces (2" minimum). The
adhesiveness of the tape does not work well with porous,
textured, or unfinished wood surfaces, soft strip clips are
required (sold separately).
PAPER BACKING
- This product is ETL listed for indoor locations.
4: Align the LED soft strip power wires so that the solid red
wire (side of connector with dot) of the power feed pin
connects to 24VDC soft strip pin. The red/black wire will
automatically be connected to the other pins.
B
SOFT STRIP
SOFT STRIP POWER
WIRE FEMALE END
4
C
LED SOFT STRIP
5
6
ALUMINUM HEAT
SINK TAPE (SS-HR-F)
SOFT STRIP POWER
WIRE FEMALE END
PAPER
BACKING
5: Push the soft strip power wire female end onto the soft strip
male end connector.
6: Carefully remove the backing from the LED soft strip, make
sure not to remove the tape from the soft strip. Firmly press
down the adhesive portion of the soft strip onto the
aluminum surface while removing the rest of the backing,
making sure there are no air bubbles that can cause surface
irregularities.
NOTE: Avoid bending the soft strip in sharp vertical angles which
may damage the LEDs. Soft Strips do not bend horizontal. Use
proper directional connectors for horizontal turns.
+24VDC +12VDC
+24VDC
+24VDC
+24VDC
100147866CHI-004
SUITABLE FOR
UNDER-CABINET &
CLOSET APPLICATIONS
CLASS 2 WIRING