Edge Lighting PSB-60W-12VDC, 60 Watt 12 Volt DC Power Supply User Manual

Page 5

LED SOFT STRIP

OUTPUTS TO LED MODULES

15: Use the "Low Voltage Wire Size Chart" on page 1 to
determine the proper wire size connecting the dim module
to the LED soft strip.

16: Run the proper size, red and black wires from the dim
module case to the LED soft strip.

17: Connect the red wire to "+" terminal of dim module
output.

18: Connect the black wire to "-" terminal of dim module
output.

19: Replace the covers of the dim module and secure them by
tightening the Phillips screws.

20: Connect the red wire coming from the dim module to the
red wire of each LED soft strip.

22: Connect the black wire coming from the dim module to
the black wire of each LED soft strip.

COVER

0-10V

Dimming

LED +

LED -

L N G

PHILLIPS SCREW

23: Replace the power supply cover and secure it by tightening
the six Phillips screws.

NOTE: Maximum length of a single soft strip to be
connected to power supply before re-feeding is 16'.

NOTE: Use only 12 volt LED soft strip with this power
supply.

Using LED Power Supply with RGB Soft Strip & CDP or CTP
Controller

POWER SUPPLY

COVER

PHILLIPS SCREW

CASE

DVR-RGB-60

COVER

NOTE: Refer to the instructions provided with the CDP
(Color Dial Controller) or CTP (Color Touch Screen
Controller) to install, power, and program them. This
section shows typical CDP controller installation.

1
remove the cover.

: Loosen the six Phillips screws on front of the power supply to

NOTE: Use a DVR-RGB-60 (Sold Separately) with this
power supply.

2: Carefully pull off the cover from the DVR-RGB-60 driver.
(Sold-Separately).