Edge Lighting PSB-30W-12VDC, 30 Watt 12 Volt DC Power Supply - Manual (Page 3)

"N" White
"L" Black
" " GREEN T
White +
Black -
3
Using LED Power Supply with Warm White Soft Strip & 0-10
Volt Dimmer
SEL
V
10-24 V=
1-10V= 0.6 mA <
+
-
+
-
OUTPUTS TO LED MODULES
IN
F
COVER
PHILLIPS SCREW
1
CASE
PHILLIP
SCREW
COVER
WIRE
TERMINAL
BLOCK
2
DIM MODULE
1
remove the cover.
2: Loosen the two Phillips screws on the front of the dim
module (OT-DIM – sold separately) and remove the covers to
expose the terminal blocks.
: Loosen the six Phillips screws on front of the power supply to
E
COVER
0-10V Dimming
LED +
LED -
L N G
PHILLIPS SCREW
15
16
11: Connect the white power supply wire marked "+" to red
conduit wire going to the soft strip.
12: Connect the black power supply wire marked "-" to black
conduit wire going to soft strip.
13: Connect the red conduit wire to red soft strip wire(s) with a
wire nut.
14: Connect the black conduit wire to black soft strip wire(s)
with a wire nut.
9: Use the "Low Voltage Wire Size Chart" on page 1 to
determine the proper wire size connecting the power supply
to the LED soft strip.
10: Run the proper size, red and black wires from the power
supply case to the LED soft strip.
NOTE: Maximum length of a single soft strip to be
connected to power supply before re-feeding is 16' of SS1
or 8' of SS3.
NOTE: Use only 12 volt LED soft strip with this power
supply.
15: Replace the power supply cover and secure it by tightening
the six Phillips screws.
NOTE: Skip this section if using the LED power supply
with a RGB soft strip.
2
"N" White
"L" Black
" " GREEN
White +
Black -
D
14
13
LED SOFT STRIP
12
11