Edge Lighting T-Bar Clip - Manual

SAVE THESE INSTRUCTIONS!
- This accessory should be used with Edge Lighting Cirrus
Channel.
- The T-Bar clip fits on 9/16" and 15/16" T-Bar grids.
- It is recommended that T-bar clips be installed 20" apart.
IMPORTANT INFORMATION
CC-TBAR-_
Installation Instructions for Drop Ceiling T-Bar Clip for Cirrus
904-CC-TBAR-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
Install the T-Bar Clip
1: Open the T-Bar clip arms to fit over the grid.
2: Select the location on the grids where the standoff will be
mounted.
A
GRID
2
B
T-BAR CLIP
GRID
3
3: Place the T-Bar clip onto the grid and squeeze the arms
together to secure it in place.
1
T-BAR CLIP
© 2013 Edge Lighting. All Rights Reserved.
1
Install T-Bar Mount To Cirrus Channel
1: Loosen the two #4-40 set screws (DO NOT REMOVE) on
the end cap at the non-power side of the Cirrus channel
using a 0.05" Allen wrench.
C
2: Slide the end cap out of the channel.
D
END CAP
CIRRUS CHANNEL
0.05" ALLEN WRENCH
#4-40 SET SCREW
END CAP
CIRRUS CHANNEL
1
2